with the ignition off press and hold the miles reset button in on dash now turn on ignition and start engine 'service now' should now be displayed now turn the clock adjuster button either left or right and this should rest the service noification.
CHECK
This could mean that your car is due for service , on the Sharan 1.8t the oil light needs to be reset after service, you find the reset plug to which you connect the device to reset the light under the ash-tray. Or, it coud that the oil pump is mulfunctioning, there is not enough system oil pressure.
Press the step button until zero miles to service is displayed. Press and hold reset.
That can only be done by a service tech, the car is so new that it will not reset even if you disconnect the battery**the above is incorrect.To reset the service light, turn ignition switch to ON position with engine off. Observe speedometer display and tachometer multifunction display. When standard display appears press up or down arrow on the multifunction steering wheel until the FSS service indicator with one or two wrenches appears in speedometer display and service deadline appears in tachometer display.Now, press the reset button between the speedometer and the tachometer for about 4 seconds or until the tachometer display shows "Do you want to reset service interval? Confirm by using the reset button" To confirm hold down the reset button again until a signal is heard. the service indicator will display the reset interval. Reset is complete.
2009
To reset the service display on a 1998 SLK230, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds. Then, turn the ignition off and back on to complete the reset. The service display should now be cleared.
Move through the overhead display to where it says perform service. Hold down the Reset button for a few seconds and it will reset to "3,000 miles to service"
With the ignition on hold down the mileage reste button until you get 4 dashes or use the socket under the ash tray to connect the vag reset tool.
To reset the service notification on a Porsche Cayman S, first, turn the ignition on without starting the engine. Then, press the accelerator pedal fully three times within 10 seconds. After that, turn the ignition off and back on to check if the service reminder has been reset. If it persists, consult the owner's manual for specific instructions related to your model year.
To reset the service indicator on a Skoda Fabia, turn on the ignition without starting the engine. Press the trip reset button on the instrument cluster until the service interval display appears. Then, hold the button down for a few seconds until the display resets to the next service interval. Finally, turn off the ignition to complete the process.
Answer : to reset the display do the following : with the ignition switched off, press and hold the trip meter reset button below the speedometer. Switch the ignition on and hold the reset buttton for at least 10 seconds. Dashes appear in the display. The service has been reset.
You can reset the service light by bringing of the oil life monitor on your display. Hold the scroll button in until the oil life goes to 100 percent. This should reset your service light.