With ignition turned on, using the trip switch , change the display to ODO, and then turn the ignition OFF. While pressing the trip switch,turn the ignition switch ON and hold for five seconds Release the trip switch,then press the switch again within five seconds.The digital display should change to T- BELT MODE. Each press of the switch then should change the reset time by 10,000km increments. After setting the klms hold the trip switch ON for more than five seconds then release the switch. Check that the display has now changed back to ODO and that now the warning has gone off when the engine is started . Hope this is helpful.
The easiest way to reset the timing belt indicator lamp in your Toyota automobile is to remove the fuse for the indicator lamp. Keep the fuse out for approximately 30 seconds. Put the fuse back in and the indicator light should be off.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
The best way is to use the users manual. If this does not help you, then it is a good idea to visit a mechanic.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
The SRI lamp may only be reset with the use of a DRBII scan tool, or equivalent. If this is not available, you will have to take the vehicle to a properly equipped shop for them to reset the lamp.
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
replace the burnt out bulb
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
I believe if you turn on the ignition key (do not crank engine) and depress the gas pedal three times it will reset itself.
There is no reset for taillamp failure relay. If there is a fault the message will continue to be displayed www.lextechautomotivellc.com