If your airbag warning light is on, try and remove minus on your battery, wait for a couple of seconds and put it back together again. If you are lucky the airbag warning light will not show.
But you should have a mechanic to take a look at it, a malfunctioned airbag can be dangerous if it dosent deploy if you crash.
And you can only reset the warning light/sensor with a car diagnostic computer for checking and removing error codes, if the first thing i said didn't work.
Hope this helps.
How. Do reset airbag light on a 1993 grand marquis
You will first need to check that the airbag has been properly set up. Then you can go into your settings and get it all reset.
You don't; your local VW dealer does. ;)
That is an oil level sensor.
There is NO fuel reset button.What are you trying to do?Dean
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
Either reset with a scan tool, or by unhooking the battery.
It depends. If the sensor is working, just reset the computer. Otherwise you have to change the sensor.
Check the temperature sensor
location of oil sencor
A 1993 Jeep Grand Cherokee does not have a speedometer cable. The speedometer signal comes from a sensor on the transmission or transfer case.
you usually reset the computer by removing the negative battery terminal for about 5 minutes, then replace it