KEYLESS ENTRY SYSTEM
With the keyless entry keypad, you can:
• lock or unlock the vehicle doors
without using the key.
Your vehicle has a factory set 5 digit
code that operates the keyless entry
system. You can also program your
own 5 digit personal entry code. The factory-set code is located:
• on the owner's wallet card in the glove compartment
• or at your dealer.
When pressing the controls on the keyless entry keypad, press the
middle of the controls to ensure a good activation.
This system will disable the power door lock controls. These will not
work until the vehicle is disarmed.
Programming your own personal entry code
To program your own code:
5. Enter factory set code (keypad will illuminate when pressed).
6. Press 1/2 control within five seconds of step 1.
7. Enter your personal 5 digit code.
Enter each digit within five seconds
of previous one.
8. After the code is entered, the
locks will cycle, confirming that the
new code has been set.
Do not set a code that includes five of the same number or presents
them in sequential order. Thieves can easily figure out these types of
codes.
Your personal code does not replace the permanent code that the
dealership gave you. You can use either code to unlock your vehicle. If a
second personal code is entered, the module will erase the first personal
code in favor of the new code.
Locks and Security
149
Locks and Security
If you wish to erase your personal code, use the following instructions:
1. Enter factory set code.
2. Press 1/2 control and release.
The system will now only respond
to the factory set code.
Anti-scan feature
The anti-scan feature prevents
repeated attempts at arriving at a valid key code.
The keyless entry pad is disabled for 1 minute after 7 unsuccessful
attempts (35 consecutive button presses) at entering a valid key code.
The keypad will flash during this 1 minute mode. However, the 7/8 and
9/0 controls will still lock the vehicle.
Anti-scan will be turned off after:
• one minute of keypad inactivity.
• the remote entry transmitter UNLOCK button is pressed.
• the ignition is turned to the ON position.
Unlocking the doors with the keyless entry system
To unlock the driver door, enter either the factory set code or the
personal code (each digit must be pressed within five seconds of the
prior digit). The interior lamps will also illuminate.
To unlock all doors, enter the factory set code or personal code (driver
door unlocks) and press the 3/4 control within five seconds.
Locking the doors with the
keyless entry system
It is not necessary to enter the
factory or personal code prior to
locking all doors. To lock the doors:
• with the driver's door closed, press the 7/8 control and the 9/0 control
at the same time.
Locks and Security
150
The factory alarm is reset with the remote or by unlocking the door with the key.
The alarm is reset with the remote or by unlocking the door with the key.The alarm is reset with the remote or by unlocking the door with the key.
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
the factory alarm is turned on and off by the drivers door-key-switch....or with the factory remote if you have one...unlocking the door with the key turns off the alarm...:)
The key in the door
get the black wire and then the red wire and then pull the chip out of it and take the key and unlocked the dricer door
There is no reset button. The alarm is disarmed by using the remote or turning the key in the door lock.
The 2001 Dodge Neon factory alarm system does not have a reset switch. Instead, you need to insert the key into the driver's door and turn to unlock the door. Next, turn the key clockwise to initiate the alarm and turn counterclockwise to stop the alarm. Once you stop the alarm, it will reset itself.
Open the door and it will turn off
how do you get the entry codes for expedition eddie bower
You unlock the door with the key or with the remote.
It can not be disabled, it is reset with the remote or by unlocking the door with the key.It can not be disabled, it is reset with the remote or by unlocking the door with the key.