answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you reset the ambient air temperature sensor on a 1998 pontiac grand prix GT?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is ambient air temperature sensor on a 2004 dodge grand caravan?

underneath the front bumper in the middle.


1993 Pontiac grand am cooling fans don't come on?

Check the temperature sensor


What would cause a 2001 Pontiac Grand Am's engine temperature gauge to not work?

Coolant Temperature Sensor


What does check engine code P0071 for a 2006 Dodge Grand Caravan mean?

P0071=Ambient Air Temperature Sensor Range/Performance. There is a temp sensor in the fresh air intake that monitors the ambient air temp coming into the engine. Check to see if it is disconnected. On this van, the ambient temperature sensor is located in front of the bottom of the ac condenser.


Replacing 1999 Pontiac Grand Am MAP sensor?

were is my 1999 pontiac grand am map sensor location


How do you replace the temperature sensor on a 2000 Pontiac Grand Prix?

Losen the exhaust cross over and take off temp sensor


Where is the coolant temperature sensor on a 2005 Pontiac grand prix?

it is located below thermostat on driver side.


Where is the transaxle fluid temperature sensor located on a 2003 Pontiac grand prix gtp?

The fluid temperature sensor is located on the left side of the transaxle. It is held in by a single bolt.


Where is the AIT sensor in a 1999 Pontiac Grand Am?

The 1999 Pontiac Grand Am AIT sensor is located on the outside of the air filter housing. The sensor will be on the back of the housing.


Where is Jeep Grand Cherokee Laredo outside temperature sensor. Temp always reads 0C. will sensor replacement fix this?

The Ambient air temperature is monitored by the Electronic Vehicle Information Center (EVIC) through ambient temperature messages received from the Body Control Module (BCM) over the Programmable Communications Interface (PCI) data bus network. The BCM receives a hard wired input from the ambient temperature sensor. The ambient temperature sensor is a variable resistor mounted to a bracket that is secured with a screw to the right side of the headlamp mounting module grille opening, behind the radiator grille and in front of the engine compartment. The ambient temperature sensor cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.OPERATIONThe ambient temperature sensor is a variable resistor that operates on a five-volt reference signal sent to it by the BCM. The resistance in the sensor changes as temperature changes, changing the temperature sensor signal circuit voltage to the BCM. Based upon the resistance in the sensor, the BCM senses a specific voltage on the temperature sensor signal circuit, which it is programmed to correspond to a specific temperature. The BCM then sends the proper ambient temperature messages to the EVIC over the PCI data bus.The temperature function is supported by the ambient temperature sensor, a wiring circuit, the Body Control Module (BCM), the Programmable Communications Interface (PCI) data bus, and a portion of the Electronic Vehicle Information Center (EVIC) module. If any portion of the ambient temperature sensor circuit fails, the BCM will self-diagnose the circuit. A temperature reading of 130° F will appear in the EVIC display in place of the temperature when the sensor circuit is shorted. A temperature reading of -40° F will appear in the EVIC display in place of the temperature when the sensor circuit is open.


Where is the crankshaft sensor located on a 1996 Pontiac grand am with 2.4 motor?

were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine


Where is the temperature sensor on a 1992 Pontiac Grand Prix?

Its located on the radiator passanger side about 3" below the radiator cap.