Want this question answered?
you reset your car. It should be in the trunk.
After repairing the failure that caused the code, the lights will reset themselves.
It could be a fuse , a sensor , or some other problem with the anti-lock braking system ( as long as the " brake " light in your dash is not on , you still have " normal " braking ) it means air brake system and it has something to do with your brakes. unhook the battery cable and let it reset and that will tell you for sure if you have something wrong let it reset for 15 minutes
Service it ;)
ABS (Anti-Lock Brake System). If the light is on then you have a problem with that system.
If the Anti-lock Brake System ( ABS ) warning light is on , a problem has been detected with the Anti-lock Brake System It could be a fuse , a sensor , or some other problem As long as the red " BRAKE " light in your dash is not on you still have " normal " brakes
Disconnect the battery for 15-30 Mins and it will reset automatically.
under the dash above the emergency brake pedal is a light blue colored box, inside that is a reset button that you can insert a small screwdriver to press it and the light will be reset.
reset brake wear display on dash board after changed rear disk brake ?
The brake light in the dash comes on if the parking brake is engaged or the brake fluid level is low in the brake master cylinder in the engine compartment
Make sure the brake fluid is topped off first as that will set off the light if it's low and if it's full try disconnecting the battery for about a minute to reset the light, if the light comes back on you need to see a mechanic.
brake light on dash blinking