The battery light isn't a light like the check engine light...well, it kinda is. It doesn't represent a code though. It's saying that there is something wrong with the charging system, like an alternator or battery going bad. Good Luck!!
Resetting the oil light on a Toyota Corolla Verso is very easy to do. You just need to take the battery cables off the battery for a few minutes and then put them back on. This will reset the oil change light.
How do you reset maint read light on 2010 corolla
my2003 toyota corolla the airbag light is on
disconnect the negative on the battery cable for 15 minutes and then reconnect.
Try unhooking your battery cables for a few minutes. That usually works for me.
Try either disconnecting the battery for about 10 mins. or have vehicle scanned to determine problem and/or have codes cleared
To reset the check engine light in your 2006 Toyota Corolla, you will need to attach the car to a diagnostic computer. This allows you to pinpoint the reason for the light coming on, select the correct sensor, and reset the light.
Probably the best way would be to disconnect the battery for about 30 seconds or so. That usually clears any "codes" in the computer. It does in my car anyways.
First remove battery cable. Second install your key and turn it to on. Third reinstall battery and all should be fine.
disconnect the battery
Go to Autozone or Advance Auto and borrow their OBD2 scanner and reset it. Easy and free to use
You will first need to check that the airbag has been properly set up. Then you can go into your settings and get it all reset.
buy a ford
Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.
Disconnect the battery for 5 minutes.
reset battery no charge light after battery replacement.
How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.
There is none.
If the problem has been fixed and the light remains on you need to disconnect the battery and then reconnect it. That should reset the check engine light.
Just disconnect the battery for couple minutes.
You can reset the check engine light on a Toyota by removing the battery cables and touching them together. Other than that, you will have to take the car to a mechanic and have them run a scan tool to turn the light off.
To reset the engine light on a Toyota Prius, disconnect the negative battery cable and let off for about five minutes, then reconnect it. The light should go off after the first couple start ups.
To reset the dash light indicators on a Toyota Tundra the trucks ECU will need to be reset. The simple way of resetting the ECU requires disconnecting the battery for 5 seconds. When the ECU is reset the lights will be clear.
Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla