turn the key to the on position engine not running step on gas pedal to the floor three times and wait for light to flash and go out and its reset
If the check engine light is blinking that means an engine cylinder misfire has been detected
With a soldering iron?
Disconnect the battery for approximately two minutes.
disconnect the battery for 30 seconds
You need to hook the computer up to a scan tool to read the codes. That will tell you why the light is on.
unhook the positive on the battery for 5 min. This should reset your check engine light if it doesnt then you still have issues.
Have vehicle scanned to determine the problem and have codes cleared
Probably because the light is burned out. It is pretty easy to change.
If your Chevy Venture ABS light is on, that means that there is some type of problem with your anti-lock brakes. For the light to turn off, you will need to see a mechanic and have the problem looked at.
I have Chevy Venture too. Engine service soon sign will definitely bring some troubles later related to Engine heatup specially in summser season. Right away go for the engine tune up which is not cheaper than later you are gonna pay after your engine will heatup and cease. Change all the filters with oil channge and specially throw out the plugs it already had and change it with new Bostch plugs to have better performance. Overall Chevey Venture is a fabulous van I have ever driven or seen before.
YES it does.
it can be of all stupid things a improperly fasstened gas tank cap
I've got a better question, why is this question in the Chevy venture forum ?
time for an oil change
If the check engine light is flashing off and on when the engine is running that means an engine cylinder(s) misfire has been detected . You need to have the vehicle scanned for any trouble codes to help diagnose and then repair the problem
Why are ets and engine light on in 98 Chevy cavalier
I have a 2000 venture and the traction control light came on. Where do I look first, hubs. Wiring.
Turn the key to on position, push the gas pedal to the floor three times, you should see the indicator screen flash, turn the key to off. You should be reset.
No, it comes on for an issue that causes an increase in emissions. See related question below.
Not sure about your Venture, but Chevy trucks are: Turn ignition to run (do not start engine). Press gas pedal completely to the floor three times in five seconds. Wait 10 seconds (if you have one of the oil life monitor screens, watch for it to blink.) Turn ignition switch off. Start the vehicle.
Have vehicle scanned to determine problem
sounds like a possible bad idle control valve. is your check engine light on? if so get it scanned for free at autozone
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
How do I reset the service engine light on a 2003 Chevy Trailblazer?