Under the hood, next to the battery, is a fuse box. Lift the lid (instructions are on the lid) and with the keyswitch on but the engine not running, press and hold the button that says "oil". The book says 5 seconds, but hold it for about 10. If someone is watching the dash lights while you do that, the change oil light should flash briefly. After you're finished, turn off the key, then start the engine to make sure it worked.
The oil change light in your car is there to remind you to change your oil in a timely manner. if you do not reset your oil change light, it just wont remind you to change your oil. :)
how to use bcm to reset change oil light
97 SL2 does not have a change oil light. Only the red oil indicator which means you have a serious problem
When you see the Change Oil light on, push and hold the button just like you would to reset the trip counter
check to see if there is a red button in the fuse box next to the battery. if there is push that and it should reset the oil change light.
I am guessing they mean Oil change reset button. If so. There is a reset button in the fuse box in the engine compartment. Turn your key half way, open the fuse box, press and hold the button for 15 seconds, look at your dash. If the light is flashing you have reset the oil life indicator.
Reset the change oil light on Mazda 3
There is a reset button in the fuse box under the hood on the drivers side. Open fuse box and look for the "reset" button. Turn ignition switch on, hold button in for approx. 10 seconds. If change oil light reset was successful, the oil change light will blink for a few seconds.
Your owners manual should tell you how to reset the light.
how do you reset change the oil light in a 2004 alero?
1. Remove the cover of the underhood fuse box.(uhfb), which is located under the hood. 2. With the ignition key in RUN but the engine off, press the red OIL RESET button and hold for 5 seconds. 3.If the CHANGE "OIL SOON light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. 4.If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. Reset the system again.
There is no reset switch for the fuel pump on any s-series