Check Engine Light
Dodge Dakota
VW Jetta

How do you reset the check engine light on a 2001 Dodge Dakota?

141516

Top Answer
User Avatar
Wiki User
Answered
2007-02-03 02:12:33
2007-02-03 02:12:33

disconnect the positive battery cable for about 10 minutes

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You can reset the check engine light on a 2007 Dodge Dakota by unhooking the battery. Leave it unhooked for 10 minutes before reconnecting it.

You need to have the engine and abs checked for codes.

bottom left of dash and is in red

There are pages and pages of things that can turn the check engine light on. You need to have it checked for codes to know what the cause might be.

There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.

Repair the problem and then reset it with an OBD2 scan tool.

The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions. If the check engine light is flashing a misfire has been detected

Have vehicle scanned to determine the problem - usually in the emission control system

remove neg. battery cable for 10 min. and reconnect. that should reset the light.

dodge 2001 Dakota brake lights won't burn Check the fuses. If the fuses are okay check the brake light switch.

A flashing check engine light is an indication of an engine misfire.

You can buy your own code reader or bring the car to Auto Zone. They'll check it for free.

In my 1989 Dodge Dakota the brake light is on fuse number13 it is a 5amp it also goes to buzzer, speed control, check engine light, anti-lock warning light, and other things page 12-19 Haynes 1987- 1993 Dodge Dakota Repair Manual

A Dodge Ram will have a check engine light appear when the engine needs to be serviced. You can reset this light by following the directions in your manual or by having your mechanic do it.

You will need to get the cause of the check engine light repaired.

You reset the check engine light with a scan tool after repairing the failure.

Have the problem repaired and they will reset the light. Resetting the light without repairing the problem and it will just come back on. You reset it with an OBD2 scan tool.

That is the check engine light. Looks like a picture of an engine.

a 2000 dodge ram 1500 the check engine light is on and the code says torque converter and clutch and overdrive solenoid. what do you think that the problem is?

There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.

Trouble code P0442 means:Evaporative emission control system leak detected (Small leak)

If the check engine light is blinking on your 2005 Dodge Stratus, you most likely have a sensor that is damaged or requires replacement. You can check this by accessing the diagnostic computer at the dealership.

Does the light say check gauge or check engine?

To fix a 95 Dodge Dakota with no brake lights, first check to ensure the fuse has not blown. If the fuse is good, check to ensure the brake light bulbs are not burn out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.