Disconnect negative battery cable for 5 minutes. This may or may not reset the light. If not you will need an OBD 2 scan tool. Know that if you do not repair the problem that caused the light to come on it will just come back on.
how do i reset the check engine light on a 1999 acura 3.2tl
check engine light reset on a 1999 Acura CL 3.0.. Just replaced the egr valve. Thx
with a scan tool
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
Disconnect the Battery for 5 minutes
u do a poo
After repairing the cause of the code, you reset it with a scan tool.
remove the alternator fuse for 20 seconds.
Have vehicle scanned to determine problem and have codes cleared
take it to your mechanic so he can run a diagnostic.
Remove the negative battery terminal for three minutes.
Have vehicle scanned to determine the problem and/or have codes cleared