How do i reset my anti-theft system in my 1997 nissan altima se?
how do you reset the oil light on a 2000 altima
A demonstration of resetting the Nissan Altima Window is available in the links.
1st. Push the compass and reset button at the same time. 2nd. Select "reset" to reset the compass. 3rd. Start driving slowly in a circle, until it resets.
The reset switch for the fuel pump on a 95 Nissan Altima is in the trunk. It is located next to the rear speakers.
Jeep vehicles do not have reset/kill switches.
after install a new compass in my chevy venture how to reset it?
lookup on youtube and follow altima airbag reset it's the same
put the key in the shifter
Drill it out and then ask assitance from an English man to put a magnetic compass in there
There is a small hole below the compass button that allows for something small such as a paper clip... press and hold it and it will allow for you to configure the compass..
There is no reset button on the fuel pump of '06 Nissan Altima instead you can pull out either the fuel pump relay (under the dash) or fuel pump fuse and re-insert it. Voila
In most cases you press the reset button on the compass and then drive in circles (in a parking lot) while it calibrates.
Resetting the maintenance light on a 1999 Nissan Altima requires access to the engine compartment of the vehicle. Once their locate the battery and disconnect the negative cable for 5 seconds. Doing so will allow the system to reset.
Auto Zone or Advanced auto parts can reset the light for you. They tell you they are not suppose to but many times they will.
To reset the service light on a 1999 Nissan Altima first pop the hood of the vehicle open. Prop the hood up and locate the battery, then proceed to disconnect the negative battery terminal for five seconds. The ECU should reset turning off the check engine light.
If it is the same as my 95 LS then drive to a clear parking lot, fully depress, then release the "S" reset button (you may need to use a ballpoint pen) on the front of the compass and drive slowly in a clockwise circle 3 times. That should reset it.
YES, they are the same:Fitment: 2006-2010Nissan AltimaNissan RougeNissam MaximaNissan MuranoNissan 350ZInfiniti FX35 / M35Infiniti G35 / QX56Part numbers: NZMNS111LBNAReplaces Matsushita Ballast
Yes. It requires at least 7 quite tight circles.
turn the ignition ON and set the display to compass/Temperature press the RESET button approximately five second the last variance zone number will display press the STEP button to select the new variance zone and press the RESET button to resume normal operation
With a scan tool after repairing the cause of the code.
With a scan tool.With a scan tool.