How to Reset the Change Engine Oil Message The Aztek uses the GM Oil Life System to calculate when to change your engine oil and filter based on vehicle use. It is widely thought to determine oil life by counting engine revolutions. While there is much debate about the merits of such a system as a basis for determining when to change engine oil, the system should be reset after each oil change to ensure that the CHANGE ENGINE OIL message does not appear inappropriately. There are two procedures for resetting the system, one for Aztek's with a DIC (Driver Information Center) and one for Aztek's without a DIC. PROCEDURE 1: Aztek's with a DIC 1. Turn the ignition to ON with the engine off. 2. Press the MODE button until the DIC reads "OIL LIFE LEFT/HOLD SET TO RESET" 3. Press and hold the SET button until 100% is displayed. You will hear three chimes and the CHANGE ENGINE OIL message (if illuminated) will go off. Repeat this procedure if the CHANGE ENGINE OIL message comes back on. PROCEDURE 2: Aztek's without a DIC 1. Turn the ignition to ON with the engine off. 2. Fully push and release the accelerator pedal slowly three times within five seconds. 3. Turn the key to OFF. If the CHANGE ENGINE OIL message continues to be illuminated, repeat the procedure.
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
The 2003 Ford Expedition has a V8 engine.
Auto Zone will read your engine codes FREE... They can also reset the light if you ask. However, until you fix the problem causing the engine light to come on. Even when reset it will eventually come back on.
The 2003 Ford Expedition has a 4.6 L base engine size.
Change engine oil, or check oil indicator?
The 2003 Ford Expedition's engine produces 232 hp @ 4750 rpm.
how do you get the entry codes for expedition eddie bower
If you mean for fuel mix etc comp will reset and relearn after a long enough battery disconnect. As long as engine trans combo matches computer you are fine. If you did a swap, you don't reset it, you get an ECU that matches your combo
The 2003 Ford Expedition's engine produces 291 ft-lbs. @ 3450 rpm.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
reset service engine light
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.