Dashboard Lights and Gauges
Cadillac DeVille
Oldsmobile Intrigue
Planet Jupiter

How do you reset the fuel gauge in a 94 sedan deville that will not register full with 20 gallons of gas Mine is stuck at 15 gal when full?


Top Answer
User Avatar
Wiki User
2011-10-18 21:11:31
2011-10-18 21:11:31

Your float assembly is probably sticks within the tank. It would be expensive to repair because the gas tank would need removal and the fuel pump/ float assembly is a unit. Sorry.

User Avatar

Related Questions

There is no reset for the fuel gauge. The sending unit in the fuel tank has probably failed.

There is no reset for the fuel gauge. The sending unit in the fuel tank has probably failed.

Reset a fuel gauge? There is not reset for a fuel gauge.

how do i reset theft problem for 96 caddilac deville concours

GM vehicles do not use inertia/reset switches.

Cadillac does not use inertia/reset switches.

disconnet the negetiv to the batt for 60 sec then reconnect. it should be reset .

How to reset the theft system on 1997 Cadillac Seville

A person can reset the air ride suspension on a Cadillac Deville by disconnecting the compressor wiring harness from the compressor itself. This is accomplished by putting the vehicle on ramps.

The oil gauge does not have a reset. Is malfunctioning, the sending unit has probably failed.

You can reset your 1999 Cadillac Deville air conditioning control by removing the air conditioning control fuse. Keep the fuse out for 10 seconds and then replace it to its original position.

You do not reset a master cylinder. You should bench bleed it before installing.

GM vehicles do not use inertia/reset switches.

The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.

If you unhook the battery for an hour, when you re-connect the cable it should reset the computer.

You can reset the theft system in your 1994 Cadillac Deville by putting the key into the ignition. Turn the ignition to the auxiliary position, without starting the engine. Leave it in this position for 30 seconds.

Disconnect the battery for a few minutes, then reconnect it.

You have a problem with the brake system. Once you repair the problem the light will reset itself.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.