Size of Battery forHonda odyssey 1999is 24F
all cars built after 1991 are required to have a emergancy fuel shutoff.
The 1999 Honda Odyssey OBD 2 port is on far right edge of dash; next to console; faces down
Plymouth does not use inertia\reset switches.
Try disconnecting battery for about 10 mins. or have vehicle scanned to determine problem and have codes cleared
In the 1999 Odyssey it is located in the base of the washer reservoir.
Gm vehicles do not use inertia/reset switches
Should be located either in trunk area or in front kick panels--push to reset
Factory reset for a radio in a 1999 Honda Accord can be done by a dealership. The requirements from the dealership to have this done is proof of vehicle ownership.
The Odyssey is built in the Honda plant in Alabama. The have been built there since 1999. Before that the Odyssey was actually a Isuzu built in Japan. The current Odyssey is rated the best minivan by many different sources.
Under the floor panel in the rear
My 1999 Honda Odyssey transmission went bad in 2005. The dealer replaced my transmission which was still warranty.. the warranty was lengthened to 100k miles because of problems w/these transmissions
We have a 1999 that is still purring like a kitten at 250,000
You will have to determine the source of the noise before you can fix it.
The turn signal flasher relay on the 1999 Honda Odyssey is located under the driver-side dashboard. The relay is tucked near the cabin fuse box.
Just pay for it and dont break your car in an attempt to fix it.
The 1999 to 2004, or 2nd generation Honda Odyssey seats 7. In the 3rd generation, an optional seat was added in the second row in the middle, making it capable of seating 8
Trouble code P0301 means: Number 1 Cylinder Misfire Detected
Trouble code P0505 means: Idle control system malfunction
On the 1998 Honda Odyssey , 2.3 liter 4 cylinder , it's every 105,000 miles ( The Gates website , they make timing belts etc. only shows the 3.5 liter V6 engine in a 1999 Honda Odyssey )
You cannot reset a speedometer. You can reset the trip meter but not the odometer. Reset the trip meter by pushing and holding the trip button.
Which alarm? If you are talking about the Maint. alarm that is done by holding down the milage reset button on the dash and then putting the key in the ignition and turning it until the warning lights come on, then wait until the Maint light goes out about 15 seconds, then turn off the ignition and then release the the milage reset button.
Go to http://www.micronair.us/assets/pdfs/82.pdf
upstream sensor will be located before the cat downstream sensor will be located on the cat itself