you might have to go to the dealership or something. i dont have a Ford, but i know i have to go to the dealer and have them re-program the alarm. its kinda dumb.
This is actually simple it is on your car Owners manual. To reprogram the remote entry
transmitters:
1. Ensure the vehicle is electronically unlocked.
2. Put the key in the ignition.
3. Turn the key from the 1 (LOCK) position to 3 (ON).
4. Cycle eight times rapidly (within 10 seconds) between the 1 (LOCK)
position and 3 (ON). Note: The eighth turn must end in the 3 (ON)
position.
5. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 1 (LOCK) position after you have finished
programming all of the remote entry transmitters.
10. The doors will lock, then unlock, to confirm that the programming
You have to have the factory do it, or a locksmith. (thats for resetting the remotes and codes)if you just want to reset it then unplug the battery for 10 mins then hook it back up
You do not have to reset the keyless remote after battery replacement.
Viper car alarms 5002 how do you reset after remote battery dies?
It is no BIG deal. All you have to do is rewire the whole thing. Follow the instructions in the owners manual for resetting the remote. The remote entry transmitter in GM vehicles must be reset when you replace the battery. Usually that consists of standing near the vehicle and holding the remote entry for about 10 to 15 seconds, but refer to the owners manual to make sure.
There is nothing to reset. Just change the battery and if you have it in correctly it will work.
http://www.mobileinformationlabs.com/Remote%20Program%20Pay%20Page.htm
un hook the battery then rehook battery should reset if not then bad sensor some where
Unplug the battery for five minutes
Try SPASTICPUPPY.NET.
All you have to do is disconnect the battery for five minutes to let the power drain and the computer will be reset when you reconnect the battery.
Either check your alternator or your battery life and replace as see fit.
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.