When the tires are rotated, the system needs relearn tire position. This may also be a problem in the system if the warning on the dash says "service tire monitor system". There is a service bulletin to replace a few parts and re-program the system to correct this. - TechJK
On what Car or truck. I need Year, Make, and Model to answer this!
>A friend has a 2002 Monte Carlo where his "low tire pressure" warning has >been showing on his dash display. It only happens each time he has the >tires rotated. First time he had the GM dealer reset the light. All tires >are at the same and correct pressure...any ideas?
Yes, this happened to me once. Simply reset the dashboard display after rotating tires. The system works on an imbalanced number of revolutions at the wheel sensor of the ABS. First, make sure that the four tires are identical and have identical pressure. Then reset the display.
i have a 2004 chevy monte carlo and the service engine soon light is on what does it mean?
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
in the trunk
chech the fuses......
Check your coolant level...
How do you take a rheostat out of a 2003 monte carlo
It could indicate poor battery health or a problem with the alternator.
unhook a battery cable for about 3 minutes and re-hook.
How do turn off low tire pressure light in my message center??
Usually a problem in the emission control system - have vehicle scanned to determine the problem
2057 - See sources and related links below for more information and pictures.
The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
To replace fog light bulb of Monte Carlo you must remove the entire assembly. Replace the bulb that has been hindered and replace the assembly.
commonly a wheel hub speed sender is bad.. requires a new hub/bearing assembly.
No it does not, atleast not the 97 SS
check your fuses
check your break fluid.
It should be in the fusebox with the rest of the fuses.
get the computer scanned to find out what the problem is.
Sometimes you can reset the security light on a Monte Carlo. Open all the doors and then lock them and close them. Next, use the key to unlock the front driver's side door. If this doesn't work, the car should be taken to a mechanic who can diagnose the problem. When the security light goes on, it can mean something in the security system is failing.
There is two clips that you have to take off the back of the headlight. then the whole thing will come out so you can get to the light that you are trying to replace.
Very possible a door switch is defective.