answersLogoWhite
Flats and Tire Pressure
Chevy Impala
Chevy Monte Carlo

How do you reset the low tire pressure light on your 2003 Chevy Monte Carlo?

222324

Top Answer
User Avatar
Wiki User
2015-07-15 19:02:30
2015-07-15 19:02:30

some time ago this happended to my corolla.took it to my mechanic after ensuring the pressure was fine and he simply disconnected the car's battery and then reconnected it..has been two years and no problem.

Pull the headlamp switch to the parking lamps 3 times Off, parking lamps, off parking lamps, off parking lamps, then you'll hear a beep

1

Related Questions

User Avatar

i have a 2004 chevy monte carlo and the service engine soon light is on what does it mean?

User Avatar

Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.

User Avatar

How do you take a rheostat out of a 2003 monte carlo

User Avatar

It could indicate poor battery health or a problem with the alternator.

User Avatar

unhook a battery cable for about 3 minutes and re-hook.

User Avatar

How do turn off low tire pressure light in my message center??

User Avatar

Usually a problem in the emission control system - have vehicle scanned to determine the problem

User Avatar

2057 - See sources and related links below for more information and pictures.

User Avatar

The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.

User Avatar

To replace fog light bulb of Monte Carlo you must remove the entire assembly. Replace the bulb that has been hindered and replace the assembly.

User Avatar

commonly a wheel hub speed sender is bad.. requires a new hub/bearing assembly.

User Avatar

No it does not, atleast not the 97 SS

User Avatar

It should be in the fusebox with the rest of the fuses.

User Avatar

get the computer scanned to find out what the problem is.

User Avatar

Sometimes you can reset the security light on a Monte Carlo. Open all the doors and then lock them and close them. Next, use the key to unlock the front driver's side door. If this doesn't work, the car should be taken to a mechanic who can diagnose the problem. When the security light goes on, it can mean something in the security system is failing.

User Avatar

Very possible a door switch is defective.

User Avatar

the wiring is probally defected or the light is burned out

User Avatar

This is the light for your security system. Shows that it is working.

User Avatar

There is two clips that you have to take off the back of the headlight. then the whole thing will come out so you can get to the light that you are trying to replace.

User Avatar

The tool required to pinpoint diagnose the ABS issues in the 1995 Monte Carlo Z34 is a $4000 diagnostic tool. The garage will charge you $100 for the scan.

User Avatar

AFTER you inflate the tires to the correct pressure, turn the ignition to the on position. Then pull the headlight knob from the OFF position to the parking light position three times. This should reset the system. This is the easiest way but you can also reset it through the radio. If you would rather do it this way, it is on 6-44 in your owner's manual

User Avatar

have vehicle scanned to determine the problem

User Avatar

instrument cluster is shorted out or corroded


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.