To reset the indicator:
-The car should be off
-hold down the left instrument button (the trip odometer reset)
-while holding the button, turn the ignition to position 1 (radio)
-keep holding the button
-after 10 seconds the word "reset" will appear, then start to blink.
-while "reset" blinks, release the button and press it again
-release the button and press again
-The indicator is reset!
How do you reset the oil service warning light manually on a 2003 BMW 525i?
how can i reset rear brake pad warning light on 2006 bmw 525i
How do you manually reset the oil life monitor on a BMW 525i
You need two special BMW reset tools.
The check engine light on a BMW 525i is reset by pressing the trip reset button until the engine icon appears. The Check and DC buttons are used to navigate between menus and the trip button held to actual reset the selected error.
diconnect the battery for 2 minutes
You will need a compatible BMW scan tool to reset this service light from the I drive system.
http://www.unofficialbmw.com/e36/electrical/e36_reset_service_lights.html Here lies your answer
In order to reset the radio in a 1992 BMW 525i, you will need a five digit code from the manufacturer. Once you receive the code, you can check your user manual for the correct sequence to reset the radio.
When a check engine light comes on the driver needs to fix the problem for the cause of the light to come on. If the light stays on, then need to perform The Stomp Test.
Where the fusebox is!
Add more fluids
Sit in the driver's seat. Put your seat belt on. With the key in the off position, press and hold in the odometer reset button. Turn the key one click (keep holding the odometer reset button in). Very shortly afterwards you will get a "RESET" (or similar) display. Release the odometer reset button. The display "RESET" will blink. While blinking press the odometer reset button again. That should do it.
The light is reset with a smallish BMW or aftermarket device that can be purchased relatively inexpensively. On Ebay, for example. There's a port it plugs into under the hood, then follow the device's printed instructions, which is, push a button, basically. Very easy. Get on with your bad self in that Bimmer.
no ! i have not seen one yet
in trunk, right side of rear panel.
I have same problem on 1994 525i. Need a new control module which no one seems to have.
how i rem placing 2004 BMW 525i solenoid vanos unit.? because my car no change in 4 and 5 speed
In the fuse 76 socket.
The type of coolant recommended for a 2003 BMW 525i is Glysantin G48. You can purchase this at an auto parts store or a BMW dealership.
The brake lights on a 2001 BMW 525i are replaced by removing the retaining screws, pulling the light assembly from the vehicle, and disconnecting the bulb. A new bulb is then put in place and reassembled.
cycle thur the check control messages in the disply using the turn signal stalk knob, when u get to the oil service due message, press and hold the bc button. You should get a reset service message displayed.
replace the light module
Castrol import multi-vehicle atf
One is in the trunk next to the battery and the other is in the glove box.