a SCAN TOOL HAS TO BE USED TO RESET THE LIGHT. FOR EXAMPLE, WITH A SNAP-ON SCAN TOOL THERE IS AN OPTION ON THE SCROLL DOWN LIST THAT SAYS "RESET EMR LAMP"
on the back of the instrument group in the dash is a small hole that you insert a push-pin tool into to reset the latch relay that was activated by the odometer to enable the light. You can reach it with a jewelers screwdriver, but you need to disconnect the battery first (is the stereo off before disconnecting the battery?) and turn the camlocks that hold the backplate up. Better idea is take it to the dealer and have them reset it for you. It is there to remind you to have the timing belt replaced and the O2 sensor checked. if either fails, you will regret this decision to ignore the service call.
The maintenance required light requires a scan tool to be reset.
maintenance with engine
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
aperantly take the light out
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.
With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.
How do you reset the maintenance light on a 2001 Honda accord ex I found some options at http://www.tegger.com/hondafaq/maintenance-reqd-light.html#why
Read your owner's manual.
disconnect the battery
Just found out that it must be reset at the dealership with a diagnostic computer
Your owner's manual discusses this very light. The light indicates that regular scheduled maintenance is required. Look in your owner's manual for the description of what maintenance items need to be addressed, and how to reset the light.