I assume you are referring to the "Service Engine" read out on the center display on the lower dash.
I'll give a more exact answer the next time I'm in my 1997 Jeep Laredo, but there are two buttons on the display. Press and hold one of them to reset the "miles till service" countdown to 3000, 6000 or 9000 (I think). Kind of like setting a car clock. Hope this points you in the right direction.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
you usually reset the computer by removing the negative battery terminal for about 5 minutes, then replace it
To reset the oil change required light: turn key on, engine off; press gas pedal to the floor three times; cycle key.
Turn the ignition on, engine off. Press the gas pedal to the floor three times in 10 seconds.
you un plug the jeeps battery for a few minuets and then the computer resets.
You will need to fix the sensor or the wiring to it.
AnswerThe answer can be found in your owner's manual.Key on, engine off.Press "step" until "0 miles to service" is displayed. Press and hold "reset".
You can unhook the battery for ten minutes.
Unplug or replace maint. timer
On your overhead console, hit "Step" until you see the miles to serice. Then you just hold your reset button and it will change to 3000 miles
Simply turn on your engine, then momentarily press select button display followed by holding down the set button