From Owners Manual:
How to Reset the Oil Life System
The GM Oil Life System calculates when to change your
engine oil and filter based on vehicle use. Anytime your
oil is changed, reset the system so it can calculate when
the next oil change is required. If a situation occurs where
you change your oil prior to a Change Engine Oil light
being turned on, reset the system.
After changing the engine oil, reset the system by
performing the following steps:
1. Turn the ignition key to RUN with the engine off.
2. Fully press and release the accelerator pedal three
times within five seconds.
If the Change Engine Oil light is flashing, the
system is reset. The light will flash for up to
30 seconds or until the ignition is turned off.
If the light comes on again and stays on for 30 seconds
at the next ignition cycle, it did not reset. You will
need to reset the system again.
The ABS light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself.
fill the coolant reserve and the light should go out
2002-2003 Saturn Vue 3.0L V6Under the hood you will see a black fuse box behind the battery.Open it up and you will see a red button, it is small and looks like a fuse but on the top it will say Oil-Res.Press and hold it for 30 sec.Service engine soon light will start to blink for a minute and that will reset the Oil light.If it doesn't and light is on next time you starts, reset it once again.2002-2007 Saturn Vue 2.2L manual trannyWith ignition key on but the engine not running, press gas pedal 3 times. Change oil will blink and it will reset it.
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
AnswerTo reset the change oil soon light turn the key to on (not run) and step on the gas to the floor 3 times fast.ACCORDING TO THE 2003 OWNERS MANUAL1. With Key on, (a short time after turning off the engine), press reset button located on drivers side instrument panel fuse block . Button is located at top.2. When the change oil light starts to flash, press and hold the reset button again3. The reset is complete when you hear the chimes and the CHANGE OIL light goes out
no you wait till you it changed
I am guessing they mean Oil change reset button. If so. There is a reset button in the fuse box in the engine compartment. Turn your key half way, open the fuse box, press and hold the button for 15 seconds, look at your dash. If the light is flashing you have reset the oil life indicator.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
How do you reset service light in 2003honda pilot
reset service engine light
Reset light when replacing headlight