um that's bad. It's an automatic light, which means that it goes out when the problem is fixed, like your door ajar light. So this probably means you need oil. If you don't know how to do this, real quick, make sure car is off. Down on the bottom side of the driver seat foot area up against the wall by the door under the dash there is a hood release. Pull it towards you. Go to the hood, feel around for the safety release and push it up. Then pull the hood up. The dipstick is colored yellow w/ a circular tip. Pull it out, clean it off, then check it twice. Make sure there is oil on it to a specified level.
How do you reset the oil service warning light manually on a 2003 BMW 525i?
how do you reset the alarm system service light on a 2001 volvo s80
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
How do you manually reset the oil life monitor on a BMW 525i
To reset the oil service light manually on a 1996 BMW 318i, disconnect the battery. Leave it unhooked for 10 to 20 minutes.
Dealer
how do you reset engine light on 1991 volvo 240
hi, disconnect the battery for 5 minutes.
To reset your service light here are the steps. 1. Get in your car and shut the door. 2. Put your key in the ignition 3. Turn your ignition key to position 1 4. Push in your Odometer reset button and hold it in while holding it move the ignition key to position 2 while holding down the odometer reset button. 5. After couple of seconds of holding the button down and the key in position 2 your service light will start to blink once that happens let go of the reset button and start the car. This should reset your service light and a service light on your Volvo C/S/V70 cars from 1999 onwards.
You will first need to properly reset the light. If this does not reset the light, then you may have to manually press it.
Ground out the # 7 pin in the data connector for 5 seconds. With the key in the acc position. Ground it out for 10 seconds to reset service light. BE SURE ITS THE RIGHT PIN. there numbered. EchoSai
Ignition to Pos1 Push and hold in odometer reset button Ig switch to Pos2 Wait until service light blinks, then release odometer button