Want this question answered?
reset run flat indicator
Turn on the key and scroll though the menu on the instrument cluster using the arrow buttons. When the run flat indicator message comes up, push the reset button. Once you do that, it will ask you to confirm the reset.
Magic and luck, with a little skill. Good luck.
Run flat tires are special tires that can drive even if punctured and completely flat. Their sides are specially reinforced by steel or rubber so they can support the whole car mass. The indicator indicates if a tire lost pressure i.e. was punctured. If a warning comes out, you have to stop driving and inspect the tire. If it is flat, you can continue driving for another 100 miles (160 km) but you must not exceed the speed of 60 mph (90 kph). Sometimes there could be also a false alarm. Especially if you have put new tires of another diameter.
Hold down the tire indicator button for about 10 seconds while driving. That is located under the Hand Brake.
i have a 520 d bmw 06 have put a normal tyre on and other 3 tyres are run flats dash board still comes up with a flat tyre ,how do i reset this please
turn the ignition to the run position but do not start it, pump the gas pedal 5 times til you hear a chime noise that indicates that the oil change indicator light is reset.
Turn ignition to "run" (don't start) push the gas pedal 3 times within 5 seconds.
if you're currently doing another run, then yes, you have to reset.
Turn the ignition to run (one position before starting engine). Press and release SETUP to display "OIL LIFE xxx% HOLD RESET = NEW". Press and hold RESET for 2 seconds and then release to reset oil life to 100%. Turn ignition off and then start engine to verify the indicator has been reset.
2007-2010Turn the ignition to run (one position before starting engine).Display the OIL LIFE REMAINING on the DIC (i) button. If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display.Press and hold the SET/RESET (check mark) button on the DIC, or the trip odometer reset stem if the vehicle does not have DIC buttons for more than 5 seconds. The oil life will change to 100%.Turn the ignition off and then start the engine to verify the indicator has been reset
TIR stands for 1. TOTAL INDICATOR RUN OUT 2. TOTAL INDICATOR READING 3. TOTAL INDICATOR REVOLUTION