Wiki User
∙ 2011-09-12 21:13:27I hate to answer a question with a question, but it would help to know which ones are on. The oil change warning is done by putting the igniton switch to the run/acc position. Run/acc position is just before the start position. Then push the gas pedal down and up 5 times methodically within 7 seconds. The oil change light should then flash 3 times and reset. If there are multiple lights on I would take it to Autozone and have the DTC codes read and cleared. If the DTC codes cannot be read or reset, you might be looking at an engine control module. Most warning lamps have Vbatt or ground in common and the engine control module will put the opposite polarity to the other side of the lamp. It would be hard for me to see multiple lamps on due to a short or open. My low coolant lamp has been a nuesance ever since I bought my 1999 Monte Carlo. Temperature guage is normal and the coolant level is good, but idiot lamp comes and goes.
Wiki User
∙ 2011-09-12 21:13:27what are the warning lights in the Chevy cavalier z24. and what do they mean
none
My dashpanel lights stopped working in your Chevy Monte Carlo ss 2001 what could the problem be
If the warning lights go off in a Chevy Tahoe, it indicates a problem. In order to reset these lights the problem must be solved.
None of the interior lights work so I think it might be a fuse?
the location of the hazard lights is on top of the steering colum.
There are 2 separate flashers.jd
probbly the fuse box....
Closing the door turns off interior lights on a 1997 Chevy S10 because there is a switch in the door jamb that closes when the door shuts. When the door opens, the switch opens.
there is a switch on the ceiling of the van
If a 1987 Chevy Suburban has lights and horn, but no ignition, gauges, radio, or interior lights it could be a ground wire problem. It is possible that there is a short somewhere. Also check the dome light for a possible water leak in the headliner.
Should be able to access after removing interior door panel