Sulfur melts at a much lower temperature than sand. That might be useful. Also, there are solvents which will dissolve sulfur but not silicon dioxide. Finally, there's always the magnifying glass and tweezers method.
sulfur sodium chloride sand is a homogeneous mixture (solution)
Sulfur is not soluble in water, sodium chloride is very soluble in water. Add water, and then pour through a coffee filter. When fully filtered, leave to dry.
Sulfur is insoluble in water so it can be removed by filtration.
step on it and spit on it
.,very simple.. just eat the sugar so you can able to separate the sulfur from it.. .,so simple, right.. .,do this at home..
[object Object]
Sulfur is soluble in carbon tetrachloride.
you can easily remove iron with magnet. then if you do not care about the sulfur you can set it on fire, and what is left will be pure sand. If you do care about sulfur i don't think i can help you.
Sulfur is extracted with carbon disulfide.Put sand and NaCl in water; sand which is not soluble can be separated from sodium chloride by filtration.
By using a magnet to separate the iron filings, you'd be left with the sulfur and sand mix. Selecting a solvent for the sulfur will allow you to dissolve the sulfur, and then all you have to do is put the sand in a filter and wash the sulfur through with the solvent.
fractional distillation
Sulfur is S , a chemical element . Sodium chloride ( NaCl ) is the table salt , a chemical compound . Sand represents a mineral ; the composition
Magnets would remove the iron. sugar is water soluble now you have sulfur and sand mixed. Apply heat sulfur will burn before the sand.
Fractional distillation is not the best separation method for a sand and sulfur mix. It's a very poor choice as it won't work. Use a solvent for the sulfur like dimethyl ether of, say, diethylene glycol. It will take the sulfur into solution and you can wash the solution out of the sand.
Iron fillings has the property of being magnetic, so you could pass it through a magnetic drum to remove it leaving sulfur and sand. Since sulfur is a solute it will dissolve in water leaving sand and forming a solution. You can then pass that through a filter separating the sand and the solution containing water and sulfur. Now you can put the solution in an evaporating basin to evaporate the water leaving the sulfur.
Sulfur is dissolved in carbon disulfide and extracted.Sodium chloride is soluble in water. After filtration sand remain on the filter.
First, place the sulfur, sand and iron filings in a plastic container. Next, use a magnet to remove the iron filings from the sulfur-sand mixture and surely,the iron filings will connect to the magnet, leaving the sulfur and sand behind.