Clean, adjust, and lucbricate
You can buy Bosco Sticks by the case at Gordon Food Service (GFS) Marketplace Stores.
To remove the choke on a 1991 Mazda 929, first, locate the choke assembly on the carburetor. Disconnect the choke cable from the throttle linkage and remove any retaining screws or clips holding the choke in place. Carefully detach the choke, ensuring not to damage any surrounding components, and replace it with a non-choke setup if desired. Always consult the vehicle's service manual for specific instructions and safety precautions.
Check the owner's manual, or check with Mossberg customer service. Unless the choke is rated by the maker for steel shot, not good to do.
To adjust the choke on a 1993 Geo, first locate the choke mechanism, typically found on or near the carburetor. Check if the choke is fully closed when the engine is cold; if not, you may need to adjust the choke linkage or the spring tension. Ensure the engine is warm to test the choke's operation, as it should open fully when the engine reaches operating temperature. If further adjustments are needed, consult the vehicle's service manual for specific procedures.
yes it could. i would rather not give your hamster a bamboo stick as a treat or anything else. whatever you do dont feed it to your hamster! :)
A fixed choke is a choke that can not be removed or changed.
A 454 Chevrolet engine which is experiencing a choke light while the choke is physically open, indicates the choke is not receiving power. This can be caused by a loose connection or a defective choke.
The choke lever should be down for the choke to be off. In the raised position is choke on.
choke lever pushed downwards = choke on
there is no choke its got an electric choke on the carb
Yes
Yes