choke lever pushed downwards = choke on
Your 2003 Suzuki 125 motorcycle does have an automatic choke. The 2003 Suzuki was not equipped with a manual choke.
"If you mean CG 125 then yes.It is in the carborator" No he does mean the CBF and yes it does but it is an automatic choke
The choke lever should be down for the choke to be off. In the raised position is choke on.
Standard is full choke first, then half-choke for a couple of minutes, then run.
Depends on the saw... On a Stihl chainsaw there is a four position switch. Top position is OFF, second position is RUN/IDLE, third position is HALF CHOKE and the last position is FULL CHOKE. Hold the throttle in with your finger and move the switch down with your thumb. DO NOT try to move the switch down into choke WITHOUT holding in the throttle. On a Husqvarna chainsaw there is normally a switch that you pull out towards you. However, there have been models made that you have to push a switch downwards.
gs stands for general schedule. 303-05 is level of position. a position in the federal government. could be with several agencies and different positions. a lower lever position typically around the 30k range in pay.
yes
Yes.
gs stands for general schedule. 303-05 is level of position. a position in the federal government. could be with several agencies and different positions. a lower lever position typically around the 30k range in pay.
To determine if a choke is open or closed, you can visually inspect the choke mechanism. In a closed position, the choke plate will be nearly perpendicular to the airflow, restricting it, while in the open position, the plate will be parallel, allowing air to flow freely. Additionally, many engines have a choke indicator or a lever that shows its status. If the engine is running rough or struggling to start, it may indicate that the choke is closed when it should be open.
You don't give us the model, so it is hard to answer the question. Assuming the gun does not have an obvious adjustable choke, the choke is probably not easily adjustable. A gunsmith can open the choke (from Full to Modified for example) or can install internal interchangeable choke tubes (costs around $125).
Just to the right of the LH grip you have rotating choke lever. All the way up is no choke, Rotated all the way down is fully choked.