0
What else can I help you with?
What is point gap for 72 Evinrude Sportwin 9.5HP outboard?
0.030
What is the prop nut torque for an evinrude nineteen eighty five model nine point eight hp?
For a 1985 Evinrude 9.8 HP outboard motor, the prop nut torque specification is typically around 25-30 foot-pounds. It's essential to ensure the propeller is securely fastened without over-tightening, which can damage the prop or the motor. Always refer to the owner's manual for the most accurate specifications.
A sailboat that is propelled by an outboard motor is considered to be what?
A motor craft. Unless it is moving under full sale power without motor assist it is not a sailboat at that point in time.
What is the point gap of a 1968 3hp evinerude?
The point gap for a 1968 3hp Evinrude outboard motor is typically set to 0.020 inches (0.5 mm). It's important to check the service manual or specifications for your specific model, as slight variations may exist. Ensuring the correct point gap is crucial for optimal engine performance and smooth operation.
What is the ignition point dwell setting for a 1976 25 HP Johnson outboard motor?
20degrees
What is A sailboat that is propelled by an outboard motor is considered to be?
A motor craft. Unless it is moving under full sale power without motor assist it is not a sailboat at that point in time.
What is contact breaker point?
If you are talking about points and condensor for your automobile they are located inside of your distributor located on you motor.
What is the point gap for a 50 hp Johnson outboard?
The point gap for the 50 hp Johnson outboard is set at .020".
Point gap for 7.5 mercury outboard motor?
The point gap for a 7.5 Mercury outboard motor is typically set between 0.020 to 0.025 inches (0.51 to 0.64 mm). It's essential to check the specific model's service manual for precise specifications, as there may be slight variations. Properly setting the point gap ensures optimal ignition timing and engine performance. Always use a feeler gauge for accurate measurements when adjusting the gap.
How do you ground a motor?
A motor is grounded with a lug in the motor's junction box. The ground wire in the supply cable is connected to this point. This lug grounds the whole motor frame so if a fault to ground occurs, the fault current will return to the distribution panel where the motor's supply breaker will trip and open the circuit.
What is Yamaha 2hp outboard points gap?
The magneto point gap on a 2hp Yamaha outboard is 0.35mm, or 0.014".
Point gap for 25hp evinrude out board?
used points 0.020 new points 0.022
