answersLogoWhite

0

How do you set choke on a V8 engine?

Updated: 10/20/2022
User Avatar

Wiki User

13y ago

Best Answer

some thing

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you set choke on a V8 engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you set ignition timing on a 1998 Chevy v8?

That requires an engine scanner to set the timing.


How do you set the timing on a 1998 305 V8.?

The timing is set and adjusted by the Engine Control Module according to driving situations.


What does the 8 refer to in a v8 engine?

The V8 engine has ( 8 engine cylinders )


What to set gap on spark plugs 2000 Ford Expedition?

4.6 L - V8 engine ( .054 inch ) 5.4 L - V8 engine - L and Z engine codes ( .054 inch ) 5.4 L - V8 engine - M engine code ( natural gas .044 inch ) The engine code is the 8th " character " of your VIN according to motorcraft . com


Choke problems for a 454 Chevrolet engine choke light is on but the choke is open what do i do?

A 454 Chevrolet engine which is experiencing a choke light while the choke is physically open, indicates the choke is not receiving power. This can be caused by a loose connection or a defective choke.


Where can you find a set of header manifolds for a 1987 Chevy S10 with a 350 v8 engine?

Try "Jegs"


How do you set timing 94' jeep 4.7 v8?

The first 4.7 l engine was introduced in 1999


What engine is in 94 cadillac?

Depending what make it is; Deville has a 4.9 (V8). Deville Concours 4.6 (V8)Northstar engine. Eldorado has the 4.6 (V8) Northstar engine. Fleetwood 5.7 (V8) Seville 4.6 (V8) Northstar engine.


How do you start a Weed eater Featherlite?

COLD ENGINE STARTING OR STARTING AFTER REFUELING --Set unit on a flat surface. --Slowly press the primer bulb 6 times. --Move choke lever to FULL CHOKE position. --Squeeze the throttle trigger fully and hold through all remaining steps. --Pull starter rope handle sharply 6 times. --Move choke lever to HALF CHOKE position. --Pull starter rope handle no more than 6 pulls, until engine runs. --Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. RESTARTING A WARM ENGINE --Move choke lever to OFF CHOKE position. --Pull starter rope handle until engine runs. --If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.


What is a Water Choke Carburetor?

It is a carburetor where the engine coolant is routed through the choke system of the carburetor. When the coolant is cold the choke will close. As the engine coolant heats up it opens the choke.


Why will a small engine not run unless it is on choke?

Could be that the air/fuel mixture is set too lean. Needs adjustment.


How do you start a lawnmower?

switch on push primer bulb or choke the engine set throttle pull rope or turn key