Home
Your Answer
Related Questions
On my 1991 caravan, turn the key on, hit the "Set" key so "P" appears on the screen, then push the select key, and you are now on time settings, use your dial to dial in the time and hit "set" once finished. (self discovered, and answered to share information)
Push the set button and within 10 seconds press the seek and scan buttons.
If it is like my 1991 caravan, turn the key on, hit the "Set" key so "P" appears on the screen, then push the select key, and you are now on time settings, use your dial to dial in the time and hit "set" once finished.
To reset the mpg, and timer. You need to press and hold both buttons for about 5 to 6 secs.
use a pen and adjust the hours and minutes on the radio by pushing in the switches in the two little holes on the right side of the radiojust next to the right knob
You don't, as there's no such thing as a 1991 Dodge Durango
Usually Caravan tires should be set at around 35 or 36 psi.
My 2000 Dodge Durango , my clock does not have the h or the m for setting the clock! any suggestions on how to set the clock????? Turn radio on, press set, press sel, now seek should change time.
You can set the clock, on your 2005 Dodge ram, by holding in the volume button. Turning the tuning knob as the volume button is held in. The time will advance with the tuning knob.
If the radio is the same as the 98 caravan, there are two tiny buttons to the right of the display with the letters H and M to the left of them, sstanding for hours and minutes, just use a toothpick to press each one until the desired time is displayed.
Turn the radio on. Press SET button. This puts the radio in (Program) mode. Press SEL button, then use the up and down on tune to set the hour, then press SEL and use tune to set the minutes.
look in your owners manual.
The clock on the radio can be set by two buttons found to the right on the display screen. H for hour and M for minute.
Try this. Turn radio off. Push and hold down power button. Push scan and/or seek up or down to set clock. This works with some Chrysler radios. TURNN RADIO OFF PUSH AND HOLD VOLUME NOB USE SEEK AND SCAN FOR HOURS/MIN.
unscrew the distributor pull it out about half way with the distributor cap off and turn the rotor clock wise to disired position
It is on because the abs computer has detected a malfunction and set a code.
Unplug and reconect the coolant temp sensor.
Turn on the power knob for the radio/clock. Wait until the clock display shows up. Press "set", and use the "scan" and "seek" buttons to set the time. Hope this helps!
To the right of the clock there are two small buttons labeled HR & MIN. Simply push and hold them in (one at a time) with a pen or equivilent pointy object to set clock
Push the set button then use the seek and scan buttons on the radio
It increases the cruise control set speed.
Read your owner's manual. This information can be found there.
look to the right of the radio for a button that says clock. push it and your display shoulg show "set hour" or something similar. use the radio tuning knob to set the hour. push the button again for minutes and use the tuning to set them. if you have an older van there 2 small/tiny buttons to the right of the radio display screen. use a pen tip to push them. they are marked HH and MM.
Press the set buttons for hour and minute.
If its the factory unit, look at the face of the unit and there should be 2 tiny little buttons (holes) on the front. One has an H (hours) next to it and one has an M (minutes). Use a paper clip or a pen and adjust the time.
How do you set clock on 1991 Dodge Caravan?
Asked By Wiki User
Asked By Wiki User
What is the timbre of the song dandansoy?
Asked By Wiki User
What is Hugh hefner penis size?
Asked By Wiki User
Is Duranice Pace husband dead?
Asked By Wiki User
Copyright © 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.