How do you set clock on a 1993 Chrysler Lebaron?

To set the clock on a 1988 Chrysler Lebaron you start by pressing the "set" button while the radio is on and push the volume knob in. Once you see the hour number flashing on the screen, adjust by using "seek" and press the volume knob in once you set the hour and then it will go to minutes. Adjust the minutes using the same "seek" button and press the volume knob in and the time will be set. ...

Set the clock and radio presets. Set the clock and radio presets.

You will need both hands to set the clock in the 2007 Chrysler 300. Hold the power button in and adjusts the time with the tuning knob. ...

There is no such thing as a 1998 Chrysler Fifth Avenue

There is no such thing as a 1998 Chrysler Fifth Avenue

The transmission computer has detected a malfunction and set a code.

The clock on the radio can be set by two buttons found to the right on the display screen. H for hour and M for minute. ...

turn on the radio on press set then press the power button the hour or minutes will flash turn other knob to adjust when done press (3rd time) clock is set ...

did you make sure the #1 piston was top dead center and that when you set your timing that the springs where without tension? if not its out of time ...

Turn the radio on and press the Set button. When the "P" displays, press the Sel button. Use the tuner dial to set the hour. Then, press the Sel button again and use the tuner dial again to set the minutes. Press the Sel button once more and the time is saved! ...

I had a Saturn and the way I did it was turn the raido off. Then push the left control nob till the clock starts. Push the tunner buttons to get time set. ...

To set the analog clock, located at the top center of the instrument panel, press and hold the button (located just to the left of the clock on the silver bezel, at the "nine" o'clock position) in until the setting is correct. The clock will adjust slowly at first and then quicker the longer the button is held. ...

the car probably senses that it slowed down or is set to shift at large bumps if it is an automatic and if it is a manual it might be a bad clutch ...

It's very easy.....there are two buttons on the right middle of radio....labled H(hour) and M(minute) simply push those buttons to adjust time.. ...

you first turn on the stereo then hit set and then push the volume button in and using the seek buttons on the stereo set the time. ...

On some Chrysler radios there are two round holes on the display panel of the radio with a letter h and m for hours and minutes. just take pen point and push into these holes to set the time. ...

There is a set of four small wires that go from near alternator to firewall side of engine. It is on the exhaust and where exhause meets engine near bottom of firewall. ...

turn the raido off and hit the set button, use the seek buttons, up for the hour, down for the min. ...

Turn off the radio press set adjust hour with scan button adjust minute with search button ...

how do you set the clock on a 2001 oldismobile aurora

'how do I set the clock on a 2001 mercury mountaineer'

Using a timing light, the distributor is set at twelve degrees before top dead center cylinder one. ...

If you look under the clock to the right you see two small buttons labeled H and M. H for hours and M for minutes take a pin or something with a pointed edge and press in the buttons to change the hours and minutes on the clock. ...

How do you set the time on a S10/Scan atomic clock model 86715

uhm i dont think you can set an alarm clock, but you can have a clock on your zune. go to settings and scroll till you see clock, click 'show clock' to yes and set the time to either 12 or 24 hour setting then set your time ...