you have to have you motor on top dead center.pull your old one out , there is a bolt at the bottom of the dist. take that out,,,,,,tip....first look at rotor button see were it is at on the dist. you may be able to put rotor button in the same place on the new dist. an slide it down an put bolt back on an wires.but if that dont work you have to get the motor on top dead center and get the rotor button on the #1 firing spot on the dist.cap once both are in those places you should be good....
in the distribuitor (inner)
how do you set timing on a 1985 350 gmc truck
I set my 350 olds to 30 at 2000rpm
Most Honda distribuitors has inside the ignition coil & pickup devices that produce the energy to fire up the combustion chambers allow the engine to "run" if you have a faulty distribuitor the engine won't start.
the most comon problem in hondas are the distribuitor!!
The sensor is located inside the distribuitor
yes
how do you set valve on 1998 350 vortec
Yes.
In order to set the timing on a 98 Chevy 350 vortex, you have to time with a scan tool that will let you set timing. Or let garage do it
Chevy did not make a 350 in 2001. The last 350 was built in 1999.
350 Big block?