if you have to ask you should not be touching them
tappet clearance 6bt cummins
I have same engines in my boat, and I have to do it on both. It is not easy, so I have a workshop copy as I follow. You must turn the engine into spesial marks and control the pushdowns at total 4.75 mm at the injectors. Try to get the manual befor you start on this. I will like to know if you get it done and how. Thanks.
You need the Cummins Insite software in order to do this.
use a noid light set to determine if pulse is going to the fuel injectors.
The valves and injectors, on a Caterpillar C 12 diesel engine, must be adjusted in time with each other. Use the adjustment screws on the injectors to set the timing.
Depends on what it is set at just guessing anywhere from 330 to 500
how do you change seal on the accessory drive N14red top
Because the computer has detected an emissions related malfunction and set a code.
the empty set.
need to set base idle and clean fuel injectors
Will vary with different engine and vehicle set-up types. Refer to owners manual.
Turning the fuel screw on a Cummins will determine the fuel flow tot he engine. If the screw is set too high of low then the engine will not run properly and could cause engine damage.