The rocker arm specs for a 3.1 sfi is 18 foot pounds of torque for the rocker arm nut. The nut should be set with a torque wrench as this setting needs to be accurate.
There are no torque specs on 350 Chevy engines. Set solid lifter cams with cam manufacturers backlash specifications, set hydraulic lifter cams with 0 backlash plus 1/4-3/4 turns preload. To my knowledge you don't torque valves, you adjust them.Each one must be done individually.
2008 Honda Civic lug nut torque specs are rated at 80 foot pounds. Improper torque set on a Civic can lead to the bolts seizing.
12 ft/lbs but its better to use 1/4" torque wrench set at 144 in/lb so you don't over tighten.
19ft/lbs, but i set my slip wrench to 20ft/lbs. The plug head is a 15mm on mine.
Specs are 124 inch pounds or 12 ft.lbs. tighten all to that then turn 30 degrees and your set. make sure pushrods are in correct order, some are longer than others.
the bolts are first torqued to a certain number of foot lbs. then a certain number of degrees.if you don't have access to a degreeing tool,use a standard torque wrench set to 68 ft. lbs.
torque wrench Not with a torque wrench ! Obtain your proper specs (clearance and sequence at TDC for each corresponding valve) set the valves using the specs obtained and the proper thickness gauge .Tighten each rocker to valve clearance until you have a slight drag on your gauge between the rocker and valve.
How to set the timing mark on kia clarus
The torque is 30 ft lbs, I just put a set of lifters in mine but I am going to ajustable type you can use either pn#-3674-07067014 sealed power rocker arm kit.
The manual for the 2006 Dodge Ram 2500 states that the torque on the front brake calipers should be set at 250 foot pounds. A proper torquing tool should be used.
It is set correclty when the crush sleave inside is set, during a gear setup. then it is checked with a Inch pound meter and will show while rotating roughly 5 inch # rotational drag.