Chevy S-10
Chevy Blazer S-10

How do you set the clock on a 1995 Chevy Blazer S-10 with Delco CD radio?

282930

Top Answer
User Avatar
Wiki User
2005-11-03 17:05:10
2005-11-03 17:05:10

hold in the "clock" button until the time comes up then turn use the volume and channel controls to adjust.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you reset clock radio in Chevy HHR

User Avatar

You can get your code at www.delcolockcodes.com It'll cost you $6.99 but from the reviews it seems like they're really quick and honest.

User Avatar

In our 96 Blazer S10, it was behind the radio. We had to remove the radio to get to it.

User Avatar

show me the radio in a 2002 Chevy mabliu l s or show me how to set the clock on the radio

User Avatar

You can set the clock on the Chevrolet S 10 pickup truck radio by holding in the power button and advancing the clock with the tuning button. The tuning button will move the clock setting forward or backwards.

User Avatar

turn radio off n use radio knobs to set the clock

User Avatar

Hold the button RCL and change the time by pressing up and down on the tune buttons if your car radio doesnt have the RCL buttun use the buttone that changes the view from clock to radio station.

User Avatar

http://www.installdr.com/Harnesses/GM-Wiring.pdf or try haynes.com

User Avatar

There are two fuse locations for your 2003 Chevrolet Blazer radio. There is a fuse in the wiring harness behind the radio. There is a radio fuse in the fuse box. The location of the radio fuse will be listed on the inside cover of the fuse box.

User Avatar

No. just remove the plastic piece around the radio. It pops off.

User Avatar

Check the fuses Should have 2 fuses for radio/clock one for radio and a separate one for the memory circuits

User Avatar

Turn ignition or accessory on with the key. Turn the radio off. Pull the scan button to set hours. Pull the seek button to set minutes.

User Avatar

the security system for the radio has "locked" my radio. how do i un-do that? i do not have the security/locks pod for the vehicle.

User Avatar

there should be a code in your trucks manul if not call dealership

User Avatar

You have to have the code. This is to prevent someone from stealing the radio and installing it. To obtain the code for the radio, you will have to go to the dealership with your state registration so that they can get it from the manufacture. Once you have the code you can enter it using the number buttons on the radio.

User Avatar

some older units from the 80's 90's are Fujitsu ten eclipse and Panasonic 2000 are Panasonic jbl and delco , yes delco if your Toyota radio buttons are peeling off you have a delco radio

User Avatar

,. .its under the hood under a cover. Its in a group of fuses, look under the cover & you will see their designations. . . it will be a 10 or 15 amp fuse. . & yes it is for both clock & radio. . if your radio works & the clock is still out, you will need a new radio. . .Good Luck. .

User Avatar

Contact the dealership. Most can obtain a unlock code for the factory radio. Since it's a Chevy I'm assuming it's a Delco raido. Go to www.delcolockcodes.com and they'll be able to get you your specific unlock code.

User Avatar

vvTurn your ignition to Acc, turn off your radio, hit the set button, use your seek button for hours and your scan button for seconds, once you set the time hit set again to save changes.

User Avatar

under the radio by the cig. lighter got the answer from looking at a 97 Chevy blazer


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.