0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Were is the fuel reset switch for a 91 geo storm?
Gm vehicles do not use ineria/reset switches.
How do you install a 91 Geo Storm radiator belt?
It's located right behind the tank for the headlight fluid.
How many teeth does the crankshaft gear on a 91 geo storm gsi with a 1.6 l dohc engine have?
22
Where is the fuel injector fuse located on Geo storm?
It should be in the main fuse block under the hood on the 91 Geo storm its located on the drivers side under the hood above the wheel well. Its the number 3 fuse.
Why does your geo eat up so much gas if you got tune up with new timing belt and water pumpgasketthermostat done for a 91 geo storm?
It's probobly out of time. Try retiming it.
91 Geo Storm 2 plus 2 starts idles fine but wont go above 3000 rpms?
it was a bad ignition rotor
Where is the fuel filter located on a 91 geo prism?
where is the fuel filter located on a 91 geo prism?
91 Geo Storm GSI engine temp gauge reads hot upper radiator hose is hot but lower isn't what gives?
A clog in the radiator will do this.
What is the name of the exhaust pipe piece that connects the manifold to the rest of the exhaust system on a 91 GEO Storm?
if I am not mistaken, it is the resignator. It's called the down pipe.
How many cylinders in 91 geo storm with 3 speed automatic?
There are 4 cylinders, the GSI model is a 2.2 litre and the regular is a 1.6. litre model
Will a 89 Geo Tracker engine fit into a 91 Geo Storm?
YES, IT WILL IT WILL FIT IN THERE PERFECTLY WITH NO PROBLEMS AT ALL! I HAVE BEEN CHANGING GEO ENGINES FOR 25 YEARS I HAVE PUT A 89 GEO TRACKER ENGINE INTO 91 GEO STORMS LOTS OF TIMES. WHEN CHANGING ENGINES ALWAYS CHECK YOUR MUFFLER BELTS AND MAKE SURE YOU HAVE PLENTY OF OIL, TRANSMISSION FLUID, BLINKER FLUID, AND REAR END OIL. ALWAYS CHECK YOUR SEALS ALSO. SINCERELY CHUCK DAVIS
Why would the belts on a 91 Geo Storm would keep coming loose?
Because the bolts that were used were crap. If you replace all of the holding bolts you shoudnt have a problem.
