answersLogoWhite
Honda Civic CX

How do you set the timing on a 1992 Honda Civic 1.5?

212223

Top Answer
User Avatar
Wiki User
2009-01-11 03:23:30
2009-01-11 03:23:30

go to auto zone and ask for timing diagram for your civic,they will give you step by step instructions for free,i know because i had to do this for my 92 civic,

1

Related Questions

User Avatar

To set timing correctly on a 1992 Honda Civic the distributor must be installed at the right angle. Install the distributor at the correct degrees to ensure the timing is set properly.

User Avatar

The timing on a 1999 Honda Civic can be adjusted setting the distributor to the correct angle. Setting the distributor forward to much will mess with original settings of the ignition.

User Avatar

Is the crank pully bolt on a 1993 civic 1.6 litre left or right handed thread???

User Avatar

93 civic has a timing belt... if its dual overhead cams, it is nessecary to find the timing marks.. set them properly to their marks as well as the crankshaft. once these are properly set slip your timing belt on and then find the mark for your idler pulley.. reinstall everything and drive away

User Avatar

Timing on a single-cam 1998 Honda Civic is marked on the cam shaft. The distributor will also need to be set of the appropriate degrees.

User Avatar

I have a 1998 honda 300ex that needs the timing set how do i do that

User Avatar

What is the set timing of a 1992 Mitsubishi Expo?

User Avatar

How to set timing on 1984 Honda 200s 3wheeler

User Avatar

How to set the distributor in a 1995 Honda civic

User Avatar

The water pump is located in the timing set up behind the timing cover its a good idea to replace the timing belt when u replace the water pump

User Avatar

how do you adjust the timing on a 1988 honda xr200

User Avatar

i have a 1985 Honda civic and the valves need adjusting with a filler gage but i do not no what to set them on

User Avatar

how do i check the timing on my 02 honda 350 atv

User Avatar

pull the distributor out and turn the fork one half turn and put it back in. hondas are typically only a half turn to correct ignition timing

User Avatar

i set the timing and cant get my xr80r to start?

User Avatar

The timing is controlled by the computer. There are no adjustments for the timing

User Avatar

The Best place to buy a set of brake pads for a 2009 Honda civic in on the Honda internet site. There are also many other sites in which you can find Honda brake pads for.

User Avatar

i have a 94 Honda passport, my engine is a 3.2L with coil packs. the timing is non adjustable. on the 3.1L the timing indicator is located at the front of the engine by the crankshaft pulley. the timing set is 10-degrees BTDC @ 800rpm. disconnect the set timing connector at the distributor.

User Avatar

The front tire pressure, according to firestone's site, should be set to 30 PSI, and the rear set to 29. for a 2000 Honda civic EX.

User Avatar

how do i set my timeing on a 1992 cadillac v8 4.9 liter

User Avatar

I just changed a timing belt in a buddys 1990 accord and you need to set the marks on the pulleys to same direction as your crank pulley mark is.

User Avatar

Check out my bio page for help on setting your timing.

User Avatar

Where is the inspection plug located on honda foreman

User Avatar

how i can set 1997 Mitsubishi diamante timing beltAnswerhow i can set 1997 Mitsubishi diamante timing belt


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.