answersLogoWhite

0


Best Answer

Drayton don't have the Digistat 3 manual on their page anymore (it's not the digistat +3 - a completely different thingy). You can get the manual you want from: www.123manual.com/manual-5-38139.html

Phil

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you set your drayton digistat 3 thermostat?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How tall is Ashley Drayton?

Ashley Drayton is 5' 3".


How tall is Troy Drayton?

Troy Drayton is 6' 3".


How many different jobs are in drayton manor?

3


How longe does it take to get drayton manor from mansfiled?

up to about 3 or 2 hours


How big is drayton manor?

Drayton manor is about 3/4 of the size of Alton Towers. It takes about 5-10mins to get from the entrance to shockwave (Other end of the park). It is very Big tbf. GOBster.


How do you replace the thermostat on a 2003 Ford Escape?

The thermostat, in your 2003 Ford Escape, by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will easily come out. Reverse the process to install the new thermostat.


Where about is the thermostat in a proton gen 2?

Follow the top hose from the rad to the engine..you will find the thermostat housing there..


Thermostat replacement for 92 Buick Century Custom 3.3?

If you need to replace the thermostat, you need 2-3 hours because in order to reach it you have to disassemble few other components (like MAF hosing, air filter housing). Send me a valid e-mail address and I can reply to you with a set of pictures I took when I replaced my thermostat.


Where do you fing the thermostat on a Renault Megane?

top hose from radiator will travel to the thermostat housing. thermostat is in this housing. normally has 3 bolts to remove the housing


How do you replace the thermostat on a 2010 Chevy Impala 3.5?

You can replace the thermostat on your 2010 Chevy Impala 3.5 by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will come right out. Reverse the process to install the new thermostat.


How to replace thermostat in 2005 Mazda 6?

· Disconnect the battery ground cable. Drain the coolant from the system and store it in an appropriate container. Take out the drive belt. · 2 Leave the pipe connected to the power steering pump and remove the pump with the pipe as a single unit. Push the power steering oil pump out of the way. · · 3 Take the water hose and the lower radiator hose from the thermostat. Remove the thermostat fasteners. · 4 Lift out the thermostat housing, the thermostat and the gasket. Remove the gasket and discard it. · 5 Install a new gasket to the thermostat and then set the thermostat in place. Set the thermostat housing in position and torque the fasteners to 71 to 101 inch pounds. · 6 Fill the cooling system with the appropriate type and mix of coolant. Recycle the coolant when possible. · 7 Reconnect the battery ground cable. Start the engine and test for coolant leaks.


How do you change thermostat on a 1994 Buick Skylark?

Well it depends on the type of engine you have, but that only has to do with the thermostat's location. The Haynes GM manual #38025 has instructions on how to change the thermostat in section 3-3. Amazon has copies of it dirt cheap.