It depends on the manufacturer of the pressure tank. Call them for an answer. The most common is the Sloan Flushmate system it is used by most toilet manufacturers. Kohler made their own system but it was a lemon and was discontinued they offer a retrofit tank to use the Sloan Flushmate system cost is $125 call Sloan for p/n details it has to be ordered from Kohler and will take about a month to get. Eljer also makes their own. Sloan Flushmate 800-533-3460 Kohler 920-457-4441 Eljer 800-423-5537 Repairs on these toilets can get time consuming, & expensive, replacement may be a better option. My recommendations for replacement toilets are the Toto Drake and the Kohler Cimmeron both of which are fantastic toilets that will be very unlikely to clog. Avoid Am Std Champion as there are some serious quality control issues.
Just replace the ballcock valve..
Have the new valve in hand. Cut the toilet water supply off at the commode, or even at the street meter box.Remove water tube or pipe supply and old flush valve. Install new valve and new supply line if required.
This question is vague as what is needed is whether it is the inlet stopvalve, the inlet valve itself or flushing valve.
It does not increase the pressure it remains the same as if the valve was open.
The fill valve (ball valve UK) is siezed or clogged. As the water level rises, the float-ball rises and closes the valve when the water reaches the proper level.
If your marine toilet has a "Y" valve, and you are in a No DischargeY Zone, you must be certain that the Y valve is secured in a closed position
its a squirrel
If your marine toilet has a "Y" valve, and you are in a No DischargeY Zone, you must be certain that the Y valve is secured in a closed position
The sloan valve is the best valve available to put on a toilet. If you have a toilet that is used a lot, you should definitely get one.
If your marine toilet has a "Y" valve, and you are in a No DischargeY Zone, you must be certain that the Y valve is secured in a closed position
If your marine toilet has a "Y" valve, and you are in a No DischargeY Zone, you must be certain that the Y valve is secured in a closed position
Thermoset plastic is what valve covers are made of. Sometimes they are made of metal, but normally it is plastic.
Refill valve is a very important component in your toilet since it fills the tank of the toilet after every flush. This valve uses a float to turn the water on and off. This is a plumber related work, only a professional plumber can repair it. alliedallcityinc.com
Did you flush out the valve body prior to installing the new cartridge
A sloan valve is a valve used for a toilet or sink. Unless you have a bathroom in you car there is no way you need a sloan valve for your vehicle.
It needs a new washer in it.
Install a tempering valve in water line feeding toilet. Tempering valve will mix hot and cold water together so warm water fills toilet tank which will stop condensation.