Hit the ball joint down so it is firmly seated then tighten up the nut. If the thread is slightly damaged then the tie rod may turn, in this case hold the end of the bolt with some vice grips to stop it turning and continue to tighten the nut. When the nut gets tight you will no longer need the vice grips, tighten up the nut and insert the split pin. How do you stop the ball jointsand tie rod ends from turning while trying to tighten the nuts?
while turning rotor ccw, tighten nut to 17 ft/lbs.loosen nut and while turning rotor cw do a final tighten of 17 in/lbs
The first thing you usually notice is a clicking while turning. After a while, you will hear it all the time and louder when turning.
For the brakes, check for warped rotors. For the turning, check for worn CV joints.
Snapping and cracking noises when accelerating especially while turning.
Check your brakes and CV joints
sounds like your ball joints
That is doubtful. It sounds like you have a 4x4 vehicle and the front CV axles (or U-joints depending on how it is set up) are bad. typically you can first detect the joints going bad when turning in reverse. After a while, you will begin noticing the popping while driviing forward and turning if not repaired.
yes and make cracking sound when turning. 65;
broken motor mount(s)
timing belt Whoever said timing belt doesn't understand constant velocity joints. If it is popping and jumping while turning, then you have a bad CV joint on one of the front axles. You can replace the joint for about the same price as replacing the entire axle, (2 joints). Do it yourself for under $150 or take to a shop for about $450.
SOME EXAMPLES OF COUPLE:-To remove or to tighten the cap of vessels like ink-pot, we apply couple with our fingers.-A cyclist usually applies a couple to the handle with his hand to give a turn to the cycle.-A couple is applied while winding a clock or a wrist -watch.-While turning a water tap.-While turning a pen screw.-While sharpening a pencil.-While turning a door key.
It sounds like your CV (Constant Velocity) joints are worn and need to be replaced