change the input turbin speed sensor on the drivers side, just below the battery and motor mount. comes out easily. just jack the car up on drivers side , losten nuts on motor mounts and raise car up enought for the sensor to pull out.
Button on the shifter.
there is a button on either your gear shifter or your turn signal that says hold. press and release and the light will go off. According to the 1991 Mazda MPV manual, the flashing indicates that there is an electrical problem with the transmission.
The hold light is a warning indicator. Essentially, the flashing indicates that there is an electrical problem with the transmission.
you need to change the input turbine speed sensor
Speed sensor....on transmission need changing....
I have a 2000 Kia Sportage and when the hold button is flashing, the transmission is locked in low, by the gear shift is a button that says, hold, some how it got pushed, you might have a button on the dash that says, power and economy, I read in the manuel that it should be in economy for every day driving, if you are towing something, you can use power, and the hold, it lets the transmission, pull harder, and doesn't shift as fast.
the hold light on on my mazda truck b 2600 stays on or flashing and it shut the engine off
Push the Reset button located under the dash and hold it until it flashes and stops. Release button when the flashing stops and then press again until it flashes. When it stops flashing, release button.
The manual claims a capacity of 18 US gallons. The capacity of the tanks is 18 US gallons.
hold the play and pause button until the light stops flashing
Hold the clock button in the use the the radio seek button to increase or decreas the time.
Press and hold the power button and media button simultaneously for 10sec, then release the media button.