all you got to do is find a Mexican on the street . just pay him 5$! what a deal. :)
where is the #5 injector? how long does it take to fix
Take You Apart was created in 2003.
What are you wanting to take apart on your Continental?
you have to take the injector rail off. this is located behind the coil pack. then they just pull out.
To take it apart you have to unscrew all the screws on one of the sides and it should come apart.
Under the intake manifold. Or should I say part of it. be very careful taking the unit apart .
The ECM is supposed to ground the injector to make it work. Either the ECM is bad or something that tells the ecm to fire the injector is bad. TAke it to a mechanic.
by takeing it apart
What are you trying to get to that you need to take apart the dash?
You don't take anything apart during the Hanukkah celebration.
Take Apart the Words was created on 2000-12-11.
Take off the upper intake, the regulator is on the backside of the fuel injector unit spider.
take it apart and then put it together the right way take it apart and then put it together the right way take it apart and then put it together the right way
Disconect all wiring from fuel rail and battery negative and then you will have to unclip the low presure fuel supply on top of injector the undo nut on side of injector then there is one bolt securing injector in place take out and wolla might be a bit stiff but it'll come out.
It depends upon the application you are refering to, so take your choice: - Some automobile and boating fuel systems have injector nuts for their fuel systems. - There are also injector nuts combined with steptums as part of injector assemblies or syringes for medical equipment - There are also air injector nuts used for pools and spas - Valco injector nuts can be found here: http://www.vici.com/vfit/fs_hpn.php - Here is a link for a laser ablation injector nut; http://www.cetac.com/pdfs/Black_Shale_Poster.pdf - And an injector nut for a specific gravity hydrometer; http://www.planetadeoptica.com/90715822rk21895.html
to take apart
by separating it
yes you can.
undo the screws then pull it apart
You Smash it with a hammer woolah its apart!!
No, there is not a diagram to take apart the outside of a door handle. However, there is a diagram that shows how a door is held together, and from there a person can take apart the outside door handle.
You can remove the injector, on your C 12 Caterpillar diesel engine, by removing the injector rail. Remove the retaining nut and the injector will come out.