The rear drums come off with the rear wheel hub. You Jack up the car, remove the wheel.Remove the cap in the center of the hub. Take the cotter pin out, unscrew the wheel bearing retainer nut. Pull drum and hub off as an assembly.The rear drums come off with the rear wheel hub. You Jack up the car, remove the wheel.Remove the cap in the center of the hub. Take the cotter pin out, unscrew the wheel bearing retainer nut. Pull drum and hub off as an assembly.
take the pin out of the rear diffrential and the axle should come out
Depends on which type it is. See link for more.
yes you need to take the hub of the tire to take the brakes off a car.
how to change rear hub on 2006 chevy cobalt 2.2l
The rear wheel has a different hub; the gears attach to it. Alternatively the rear hub has gears or a brake or a dynamo built into it. The front hub will sometimes have a dynamo built into it, other than that it is just a plain hub.
in what
You need a four pronged hub tool that you can rent at Kragen to remove the inner hub other than tha there is the Allen screws, a couple of spring clips and you should have it off.
The rear axle hub nut should be torqued to 260Nm or 192 lb/ft - this applies also to the front axle hub nut.
You have to replace the hub assembly which is expensive. Cost me $226.00 for one for the rear. They aren't hard to change. Take the brake caliper off. Then take the 2 bolts out on the plate that holds the brake shoes. There are three bolts holding the hub assembly in. Take them out and pull the hub out. I was able to leave the parking brake in.
How can I take apart the back of the rear seats in an 2010 rx350? I need to clean underneath. Soup spilled all over.
The torque settings for the rear hub nut (in the Haynes manual) is 175Nm or 127lb ft.