answersLogoWhite

0


Best Answer

with a punch and a hammer

User Avatar

Wiki User

โˆ™ 2008-06-05 06:44:28
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you take off a back wheel bearing on a 1986 Mitsubishi Galant?
Write your answer...
Submit
Related questions

How do you replace front wheel bearing on 1986 ford laser KC?

oops i did not mean to click on this and answer it.


Where is the fuel pump relay switch located on a 1986 Mitsubishi Galant?

Check the fuse in the fuse box in the engine compartment labeled ECI (Electronic controlled injectors) They share the same power circuit as the fuel pump.


When did Bobby Bearing happen?

Bobby Bearing happened in 1986.


When was Bobby Bearing created?

Bobby Bearing was created in 1986.


Where is the fuel pump on a 1986 Mitsubishi Galant?

there are 2,one is in the gas tank and another one ''inline'' going to the furl injector.on some models you can check under the backseat/boot area to test the wiring without actually removing the gas tank


Is a 1986 Dodge colt turbo made by Mitsubishi?

Yes


What is the 1986 Mitsubishi Montero gas-mileage?

20 miles to the gallon


What year was Mitsubishi 2501 tractor made?

From 1982 till 1986


What is the firing order for 1986 dodgeram d50 4-cylinder Mitsubishi?

The firing order for the 1986 Dodge Ram D50 4cyl Mitsubishi engine is 1, 3, 4, 2. The number one cylinder is at the front of the engine compartment.


Where is the prabhjoyt on a 1986 corvette thanks pal?

hello mate, i think it mite be just under the over arm backlash. if not try in front of the delux supreme wheel bearing thrust force lithium crystals. hope this helps mate.


A wiring diagram for a 1986 Mitsubishi pickup?

coil and disribuitor elecrtic wireing?


Is the 1986 fiero real wheel drive?

Yes , it's rear wheel drive


Why is a ball bearing needed for the transmission in a 1986 Chevy s10?

If it is a standard transmission S10 maybe they are talking about the "throwout bearing" which is part of the clutch operation that can go bad.


Is a 86 Chevy caprice front wheel drive?

No , a 1986 Chevy Caprice is REAR wheel drive


Are 1986 camaros rear wheel drive?

Yes


How do you remove steering wheel on Mercedes 1986 560SL?

how do you remove steering wheel on mercedes 560 SL 1987


What year did front wheel drive first come out?

1986


Timing chain diagram for a 1986 Mitsubishi 2.0 liter?

It has a belt, not a chain...also has a balance shaft belt


What manual transmission is in the 1986 Ford Ranger?

In a 1986 Ford Ranger : Depending on how it is equipped : You could have the : Mitsubishi FM145 , 5 speed manual transmission ( 4X4 ) transmission code " D " Toyo Koygo , 4 speed manual transmission , rear wheel drive transmission code " X " Toyo Koygo , 5 speed manual transmission , rear wheel drive and 4X4 , transmission code " 5 "


What is the torque for an 1986 Dodge 318 rod bearing bolts?

the correct torque for these bolts is as follows: 96lbs


Is the 1986 Honda 350 Fourtrax 4 wheel drive?

yes


What is the wheel bolt pattern on a 1986 Oldsmobile cutlass supreme?

5x4.75


Is 1986 caprice rear wheel drive?

Yes, all Caprice and Impalas 1996 and older were rear wheel drive vehicles.


When did Patricia Wheel die?

Patricia Wheel died on June 3, 1986, in New York City, New York, USA.


Can you transfer the four wheel drive components from a 1990 Subaru loyal to a 1986 Subaru loyal two wheel drive?

Yes, it is a LOT of work, but yes. The ONLY thing you will have to make up (well, other than getting power to the "shift on the fly") is something to hang the rear driveshaft center bearing, your 2 wheel drive car has nothing, so a couple of pieces of flat iorn, bent into an "L" shape, and mounted to the sides of the driveshaft tunnel (welded?, bolted?) will do the trick.