Loosen brake lines on master cylinder. Dont take off brake lines yet! Get under steering wheel, under the dash and look by the steering column. There will be 4 nuts. Take off the four nuts. Take brake lines off master cylider. Take out brake booster and master cylinder as one unit.
With a line wrench, seriously.
From the inside of the vehicle disconnect the clutch pedal arm. Take off the master cylinder retaining nuts. From under the hood disconnect the lines. The cylinder should slide out.
You take the cap off of the master cylinder and pour it in.
Begin by removing the brake lines. Remove the master cylinder retaining bolts. The master cylinder will come off. Reverse the process to install a new master cylinder.
no you dont have to---BUT its adviseable
Look for master link then take off master link clip then slide master link off
If a pressure type brake fluid dispenser is available attach it to the top of the master cylinder. Other wise fill the master cylinder, start with the wheel cylinder that is furthermost from the master, and bleed until fluid comes out clean and free from bubbles. make sure to replenish the the master cylinder as needed. then proceed to the next farther wheel cylinder and repeat with the rest of the wheel cylinders. top off the master cylinder. Test with the engine off then with the engine running before driving.
Master Brake cylinder replaced and lines bled-how long?
it two bolts on the master cylinder that you take off and you have to plug the lines up upon removal. or you can call mr.autofix-it for mobile repairs! 678-933-2751 located in atlanta
you need to take off the master cylinder and the accumulator and replace it with a master cylinder from a non antilock vehicle like a thunderbird or cougar from about 1985 to 1988.
Take the master cylinder off and then on the inside of the firewall where the rod from the brake pedal goes through, there should be 4 nuts holding the booster on.