Want this question answered?
Take the door panel off of the door.Remove the three bolts that hold the side view mirror on.
Take off the inside of the door panel the bolts are in tie in side of the door
take the door panel off and their are 3 nuts you must remove and unplug the power supply going to the mirror
If it's the brackets mounting the mirror to the door, you have to take the trim off the door and tighten it from the inside.
Inner door panel has to be pulled off or loose to get to the nuts that hold the mirror on, take the nuts off and if the mirror is power you have to disconnect the wires and then just pull the mirror off.
5w30 or 10w30
It was built for R12, can be retrofitted to R134a
typical Chrysler product
Take out your glove box and a few trim and it will be in front of you
Take off the door panel and unbolt the mirror housing
take the door panel off, take the plastic panle behind the side mirror off, and just remove the mirror. it should eather be held in by nuts, or mabe screws. hope that helps :D
you have to remove door panel and there are three nuts you have to take off of the mirror.