If you have an electric side mirror you have to remove the door panel then unplug the electrical connector and then remove the screws that hold the mirror.
Remove the door panel.Unplug the connector to the power mirror.Remove the three bolts from the mirror base.
open the door remove screw holding molding to base of side view mirror. seperate molding from mirror. remove bolt holding top or side view mirror to A-pillar. remove bolts holding bottom side of mirror to A-pillar. disconnect wiring connector.
If you need to remove side view mirror: you need to remove door panel and there should be 3 nuts securing mirror to door.
96 dodge ram side rear view mirror will not stay in position
Go to the following website. It will show how to remove the door panel and the side mirror. kwmuth.com
pull off plastic inside directly behind the mirror it just pulls off and you will expose the bolts to remove the mirror.
Take the door panel off of the door.Remove the three bolts that hold the side view mirror on.
To remove the mirrors from you Nissan Sentra first remove the inside door panel. Pry the plastic mirror cover off of the mirror. Once this is done remove all of the nuts, bolts, or clips holding the mirror to the door.
Remove the dppr panel and there are screws on the inside.
You will need to remove the inside door panel in order to remove the side mirror retaining bolts. Remove the wiring harness from the mirror. Reverse the process to install the new side mirror.
To remove the door panel on your 01-06 Dodge Stratus you would first need to remove the door panel. Then there are two bolts that hold the mirror to the door. You will need an 8MM socket or wrench to remove these from the mirror. I have included an instructional video below that walks you through this entire process. Hope this helps. 1aauto.com
take the door panel off and their are 3 nuts you must remove and unplug the power supply going to the mirror
Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.
To get to the side mirror switch on a 2002 Dodge Intrepid look on the driver side door. The mirror switch is located just above the window up and down switches.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
Remove the inside door panel of your Chevrolet Astro Van. Remove the wiring harness from the mirror. Remove the side mirror retaining bolts.
You have to remove the inside door panel then you can see the holding assembly
Take the door panel off and there are bolts inside.
on a 1997 blazer, how to remove drivers side mirror under your handle to close the door is two 7mm bolt and behind your handle to open the door is a Philips screw and that plate behind it comes off then CAREFULLY remove the door panel trust me you don't want to break the plastic then you will see your mirror bolts and electrical wiring
You need to remove the door panel. Remove the wires going to the mirror. Remove the nuts holding the side mirror. Reinstall in reverse order.
You will need to remove the inside door panel of your 2002 VW Jetta. Remove the wiring harness from the mirror. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.