2000 Chevrolet Tahoe tail light bulb lamp replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
take it to chevy
Depending on what you mean ,to change a bulb on the 2000 you need to open the rear door on the side of the light you will see two screws take those out and the light will come out.
to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out ken
Hey Jesse==You have to take the tail light completely off. The bulbs go in from the back Good Luck Joe
from inside the trunk just take the plastic pins out that hold the carpet directly behind the tail light and twist the light socket out and change the bulb
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
If you open the tail gate and look where the tail gate and side of bed go together where the light is mounted you will see 2 screws take them out and the light will come off then unhook bulbs and remove.
The Tail light assembly is mounted by two Philips head screws located near the boot rubber, take them out and slide the tail light assembly away from the center of the car. Then Bob's your Auntie.
No, there are no clips that have to be removed to take the tail light lens off. There should be 2 torque head screws or phillip head screws, and simply remove them.
Open the tail gate...you need to remove 2 screws that hold the tail light cover. The cover is also held in place by a couple of snap on fasterners so you need to pull the cover outward to take it off.
Begin I removing the tail light connector. Take hold of the tail light, push in and turn at the same time. The tail light will come on. Reverse the process to install your new tail light.
If the check engine light is or has illuminated check for codes. The codes may lead you to the problem.