I have a similar problem for a 2002 Chevy Malibu. I can tell you the window rocker switch comes out with two clips on the window up and down ends just put a small flathead screwdriver in-between. The small panel right by the review mirrors just pops off also no screws. And there is another small panel right behind the handle the hides two screws. That
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
Here's a great how to video that will show you how to properly remove the door panel on your 2005 Chevy Malibu. A link has been included below.
remove door panel to check it!!
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.
open the driver side door. There is a panel on the dashboard that is really easy to remove when the door is open... ope panel, see fuses and on the panel is a diagram to locate which is which!
what size door speakers are in a 2005 Chevy Malibu classic
Blocked or damaged lock or key
Look on the drivers door at the specs decal to see what the tire size is.
The 2004 Chevy Malibu dashboard speakers measure 3.5 inches in diameter. The door speakers measure four inches by five inches. The rear speakers measure four inches by five inches.
Take door panel off then it's as easy as 1-2-3
Remove the screws in the door panel.
Using a screwdriver, remove the screws that are in the door panel, be sure to remove the clips as well, and gently pull the panel away from the frame. Remove any wire connectors between the frame and the panel, and pull the panel off the rest of the way.
There is a clip on the back side of the window crank that you have to take off, then take the door panel off.
Open the Driver's door and look at the side of the dash. Remove the side panel panel.
pop out small panel behind door pull remove two torx screws , remove two pop out connectors on outer edge of door panel near door latch ,grab bottom of door panel and pull it towards you this will release panel ,disconnect wires as needed if you want to remove entire panel from door, lift up on panel to remove it from edge of window track
how to replace actuator on a 2000 malibu
You push the gas door in and it releases.
you have to take the whole door panel off and get to it form that way
To program the keyless entry remote on a Chevy Malibu, close all doors and put the key in the ignition. Hold down the power unlock button on the door while turning your key to on and off twice. Then release the power unlock button on the door.
How do you remove the interior rear door panel on a 2004 isuzu ascender?
The process for removing the door panel can be found at: http://www.bodyshopzone.com/archives/trim/door_panels/Chevy/Equinox_2005/dp_front_rear.html
You must remove those pieces that don't seem to flow with the door panel (they pop right off with a screw driver), then you will se screws underneath them... unscrew these screws and the door panel should easily pop right off.
The Chevy Malibu weighs about 3,400 pounds. The weight of a vehicle is usually posted on a part of the driver's door frame or the door itself.
A Chevy Lumina door panel is held in by screws and push pins. After removing the screws, use a special tool to pop the pins out without damaging the panel.